UNPACK THE DRAIN WATER FILTER TANK

Make sure that all components are in the box.

CAUTION

Use care when removing the packaging materials from the electrical cords. Do not use sharp objects to remove the packing material. Sharp objects can puncture the electrical cord and create a shocking hazard.

1. Remove the drain water filter tank and components from the box.

Figure 1  

[1] Tank [2] Pump control box [3] Cover [4] 90-degree elbow
[5] Filter bag (2 units) [6] Hose (to drain) [7] Pump assembly  
Note

The pump assembly comes already installed inside the tank. All other components are shipped inside the tank.

2. Remove the tank cover [3] and take the pump control box and cables [1] and hose [2] out of the tank [4].

Figure 2  

3. Take the 90-degree elbow and filter bags out of the tank and set aside.
4. Route the cables and hose through the tank cover slot [1], and then replace the tank cover [2].

Figure 3  

5. Remove any additional packaging materials on the components, if any.